06_06

VERTICAL STAB

RUDDER

ANTI-SERVO TAB

STABILATOR

TAILCONE

EMP ATTACH

EMP FAIRINGS

BUILDERS LOG

Page 06.06 Vertical Stabilizer

6.00

6.01

6.02

6.03

6.04

6.05

6.06

6.07

Step 01: Remove the material from the VS-1204 Fwd Skin, Called out in Figure 1.

07-12-10

Step 02: Remove the material from the VS-1201 Main Skin called out in Figure 2, Detail A.

07-12-10

Step 03: Final-drill #19, the nutplate screw holes in the VS-1204 Fwd Skin per call-outs in Figure 1.

07-12-10

Step 04: Final-drill #19, the nutplate screw holes in the VS-1201 Main Skin per call-out in Figure 2, Detail B.

Deburr all of the final-drilled holes from Step 3 and 4.

07-12-10

Step 05: Dimple the #19 holes in the VS-1204 Fwd Skin using a #8 dimple die as called out in Figure 1.

07-12-10

Step 06: Dimple the #19 holes in the VS-1201 Main Skin using a #8 dimple die as called out in Figure 2, Detail B.

Step 07: Dimple the nutplate attach rivet holes in the VS-1201 Main Skin using a 3/32" dimple die as called out in Figure 2, Detail B.

07/12/10

NOTE: A small diameter female die is required to dimple the nutplate attach rivet holes on a countersunk nutplate.
07-12-10

Step 08: Dimple the nutplate attach rivet holes using a 3/32" dimple die as called out in Figure 3.
07-12-10

Step 09: Rivet the previously dimpled K1100-08 Nutplates, to the VS-1201 Main Skin per call-outs in Figure 4.

Builder Note:
Step out of sequence
09/27/10